Filter
Top Products
Desktop Computer 123
Installing the Media Card Reader
1
If you are installing a new media card reader:
a
Use a small flat-edge screw driver on the back side of the drive-panel insert to gently pop off
the insert.
b
Remove the four shoulder screws from the drive-panel insert.
2
If you are replacing an existing media card reader:
Remove the four shoulder screws from the existing media card reader.
3
Insert the four shoulder screws into the sides of the new media card reader and tighten them.
4
Attach the media card reader cable to the media card reader.
5
Connect the card reader cable to the USB1 connector on the system board (see "System Board
Components" on page 102 for the connector location).
6
Align the shoulder screws with the screw guides numbered as 2, and slide the media card reader
forward into the bay until it clicks into place.