Filter
Top Products
58 Mini Tower Computer
B
efore you close the card retention mechanism, ensure that:
• The tops of all adapters and filler brackets are flush with the alignment bar.
• The notch in the top of the adapter or filler bracket fits around the alignment guide.
5
Close the card retention latch and gently press until it snaps into place.
NOTICE: Do not route cables over any installed cards. Cables routed over the cards can prevent the computer
cover from closing properly or cause damage to the equipment.
6
Connect the adapter cable to the serial port adapter connector (PS2/SER2) on the system board (see
"System Board Components" on page 28 for connector locations).
NOTE: See the documentation for the PS/2 serial port adapter for information about the cable connections.
7
Replace the computer cover (see "Replacing the Computer Cover" on page 297).
Removing a PS/2 Serial Port Adapter
1
Follow the procedures in "Before You Begin" on page 19.
2
Gently push the release tab on the card retention latch from the inside to pivot the latch open. The
latch will remain in the open position.
1 fully seated card 2 not fully seated card 3 bracket within slot
4 bracket caught outside of slot
1
2
3
4