Filter
Top Products
Desktop Computer 138
NOTICE: To connect a network cable, first plug the cable into the network wall jack and then plug it into the
computer.
11
If you installed a network adapter card and want to turn off the integrated network adapter:
a
Enter system setup, select
Integrated NIC
from the
Onboard Devices
group, and change the
setting to
Off
(see "System Setup" on page 257).
b
Connect the network cable to the network adapter card’s connectors. Do not connect the
network cable to the integrated network connector on the back panel of the computer.
12
Install any drivers required for the card as described in the card documentation.
Removing a PCI Card
1
Follow the procedures in "Before You Begin" on page 19.
NOTE: For PCI card locations, see "System Board Components" on page 102.
2
Gently lift the release tab on the card retention latch from the inside to pivot the latch open. Pivot
the latch until it snaps into the open position.
3
If necessary, disconnect any cables connected to the card.
4
Grasp the card by its top corners, and ease it out of its connector.
2
1
4
5
3