Filter
Top Products
Desktop Computer 163
PS/2 Serial Port Adapters
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the
Product Information Guide
.
NOTICE: To prevent static damage to components inside your computer, discharge static electricity from
your body before you touch any of your computer’s electronic components. You can do so by touching an
unpainted metal surface on the computer chassis.
Installing a PS/2 Serial Port Adapter
1
Follow the procedures in "Before You Begin" on page 19.
2
Gently lift the release tab on the card retention latch from the inside to pivot the latch open. Pivot
the latch until it snaps into the open position.
3
Remove the filler bracket (if applicable).
NOTE: See the documentation that came with the adapter for information on configuring the adapter, making
internal connections, or customizing it for your computer.
4
Align the PS/2 serial-port adapter bracket in the retention slot and press down firmly. Ensure that
the adapter is fully seated in the slot.
5
Before you close the card retention mechanism, ensure that:
• The tops of all cards and filler brackets are flush with the alignment bar.
• The notch in the top of the card or filler bracket fits around the alignment guide.
6
Secure the card(s) by closing the card retention latch and snapping it into place.
NOTICE: Do not route card cables over the cards. Cables routed over the cards can prevent the computer
cover from closing properly or cause damage to the equipment.