Filter
Top Products
Small Form Factor Computer 233
NOTICE: To connect a network cable, first plug the cable into the network wall jack and then plug it into the
computer.
13
If you removed a network-adapter card connector:
a
Enter system setup, select
Integrated NIC
from the
Onboard Devices
group, and change the
setting to
On
(see "System Setup" on page 257).
b
Connect the network cable to the integrated network connector on the back panel of the
computer.
PS/2 Serial Port Adapters
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the
Product
Information Guide
.
NOTICE: To prevent static damage to components inside your computer, discharge static electricity from your
body before you touch any of your computer’s electronic components. You can do so by touching an unpainted
metal surface on the computer chassis.
Installing a PS/2 Serial Port Adapter
1
Follow the procedures in "Before You Begin" on page 19.
2
Gently lift the release tab on the card retention latch from the inside and pivot the latch open.
3
Remove the filler bracket (if applicable).
NOTE: See the documentation that came with the adapter for information on configuring the adapter, making
internal connections, or customizing it for your computer.
4
Align the PS/2 serial-port adapter bracket in the retention slot and press down firmly. Ensure that the
adapter is fully seated in the slot.
5
Before you close the card retention mechanism, ensure that:
• The tops of all cards and filler brackets are flush with the alignment bar.
• The notch in the top of the card or filler bracket fits around the alignment guide.
6
Secure the card(s) by closing the card retention latch and snapping it into place.
NOTICE: Do not route card cables over the cards. Cables routed over the cards can prevent the computer cover
from closing properly or cause damage to the equipment.