Filter
Top Products
232 Small Form Factor Computer
7
If you are removing the card permanently, install a filler bracket in the empty card-slot opening.
NOTE: Installing filler brackets over empty card-slot openings is necessary to maintain FCC certification of the
computer. The brackets also keep dust and dirt out of your computer.
8
Before you close the card retention mechanism, ensure that:
• The tops of all cards and filler brackets are flush with the alignment bar.
• The notch in the top of the card or filler bracket fits around the alignment guide.
9
Secure any remaining card(s) by closing the card retention latch and snapping it into place.
NOTICE: Do not route card cables over the cards. Cables routed over the cards can prevent the computer cover
from closing properly or cause damage to the equipment.
10
Replace the computer cover (see "Replacing the Computer Cover" on page 297).
11
Uninstall the card’s driver. See the documentation that came with the card for instructions.
12
If you removed a sound card:
a
Enter system setup, select
Integrated Audio
from the
Onboard Devices
group, and change the
setting to
On
(see "System Setup" on page 257).
b
Connect external audio devices to the audio connectors on the back panel of the computer.
1 PCI Express x16 DVI-card 2 removal pull tab 3 DVI card connector
4 lever 5 securing slot 6 securing tab
7 PCI Express x16 card
connector
6
2
1
7
3
4
5