Filter
Top Products
Small Form Factor Computer 231
12
If you installed a network adapter card and want to turn off the integrated network adapter:
a
Enter system setup, select
Integrated NIC
from the
Onboard Devices
group, and change the
setting to
Off
(see "System Setup" on page 257).
b
Connect the network cable to the network adapter card’s connectors. Do not connect the network
cable to the integrated network connector on the back panel of the computer.
13
Install any drivers required for the card as described in the card documentation.
Removing a PCI Express x16 Card or DVI Card
1
Follow the procedures in "Before You Begin" on page 19.
2
Gently lift the release tab on the card retention latch from the inside and pivot the latch open.
3
If necessary, disconnect any cables connected to the card.
4
Press the lever with your thumb until you release the securing tab.
If you are removing a PCI Express x16 card, go to step 5.
If you are removing a DVI card, go to step 6
5
While pressing the lever, pull the card up and out of the card connector.
6
While pressing the lever, pull the removal pull tab up and remove the card out of the card connector.
1 PCI Express x16 card 2 lever 3 securing slot (not all cards)
4 securing tab 5 PCI Express x16 card
connector
3
2
1
5
4