Filter
Top Products
226 Small Form Factor Computer
NOTICE: To connect a network cable, first plug the cable into the network wall jack and then plug it into the
computer.
12
If you installed a network adapter card and want to turn off the integrated network adapter:
a
Enter system setup, select
Integrated NIC
from the
Onboard Devices
group, and change the
setting to
Off
(see "System Setup" on page 257).
b
Connect the network cable to the network adapter card’s connectors. Do not connect the network
cable to the integrated network connector on the back panel of the computer.
13
Install any drivers required for the card as described in the card documentation.
Removing a PCI Card
1
Follow the procedures in "Before You Begin" on page 19.
NOTE: For PCI card locations, see "System Board Components" on page 102.
2
Gently lift the release tab on the card retention latch from the inside and pivot the latch open.
3
If necessary, disconnect any cables connected to the card.
4
Grasp the card by its top corners, and ease it out of its connector.
1 release tab 2 card retention latch 3 card
4 card-edge connector 5 card connector
2
1
4
5
3