Filter
Top Products
Chassis Intrusion Switch 277
7
Chassis Intrusion Switch
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions located in
the
Product Information Guide
.
Removing the Chassis Intrusion Switch
1
Follow the procedures in "Before You Begin" on page 19.
2
If removing the chassis intrusion switch on a small form factor computer, remove the hard drive
(see "Drives" on page 205).
3
Disconnect the chassis intrusion switch cable from the system board (see "System Board
Components" on page 28 for mini tower computers or "System Board Components" on page 102
for desktop computers or "System Board Components" on page 190 for small form factor
computers).
Note the routing of the chassis intrusion cable as you remove it from the chassis. Chassis hooks
may hold the cable in place inside the chassis.
4
Slide the chassis intrusion switch out of its slot, and remove the switch and its attached cable from
the computer.