Filter
Top Products
Removing and Installing Parts 77
Connect CD/DVD drives to the connector labeled "IDE" on the system board. Serial ATA hard
drives should be connected to the connectors labeled "SATA0" or "SATA1" on the system board.
IDE Drive Addressing
When you connect two IDE devices to a single IDE interface cable and configure them for the
cable select setting, the device attached to the last connector on the interface cable is the master or
boot device (drive 0), and the device attached to the middle connector on the interface cable is the
slave device (drive 1). See the drive documentation in your upgrade kit for information on
configuring devices for the cable select setting.
Connecting Drive Cables
When you install a drive, you connect two cables—a DC power cable and a data cable—to the back
of the drive and to the system board.
CD/DVD drive(s)
FlexBay for optional
floppy drive or
Media Card Reader
hard drive
bay for second hard
drive (optional)