Dell IO2305-543MSL Laptop User Manual


  Open as PDF
of 90
 
Back to Contents Page
Infrared Blaster Connector
Dell™Inspiron™One2305/2310ServiceManual
Removing the Infrared (IR) Blaster Connector
Replacing the Infrared (IR) Blaster Connector
Removing the Infrared (IR) Blaster Connector
1. Follow the instructions in Before You Begin.
2. Remove the back cover (see Removing the Back Cover).
3. Follow the instructions from step 2 to step 5 in Removing the Front Stand.
4. Follow the instructions from step 4 to step 8 in Removing the System-Board Shield.
5. Remove the nut that secures the infrared (IR) blaster to the system-board shield.
6. Release the IR blaster connector from the slot on the system-board shield.
7. Lift the IR blaster connector along with its cable away from the system-board shield.
Replacing the Infrared (IR) Blaster Connector
1. Follow the instructions in Before You Begin.
2. Slide the IR blaster connector into the slot on the system-board shield.
3. Replace the nut that secures the IR blaster connector to the system-board shield.
4. Follow the instructions from step 4 to step 8 in Replacing the System-Board Shield.
5. Follow the instructions from step 4 to step 5 in Replacing the Front Stand.
6. Replace the back cover (see Replacing the Back Cover).
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION: Onlyacertifiedservicetechnicianshouldperformrepairsonyourcomputer.DamageduetoservicingthatisnotauthorizedbyDell™
is not covered by your warranty.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
1
IR blaster connector
2
nut
 previous next