Filter
Top Products
Configuring the I/O Modules 53
3
Select the
Setup
tab. The
Configuring
I/O Modules Network Settings
page is displayed.
4
Configure the switch for integration into your network.
– Select
DHCP Mode Enabled
if your network uses a DHCP server to
assign IP addresses.
– If your network uses static IP addressing, enter an IP address, subnet
mask and gateway.
5
When you have finished, click
Apply
.
6
Click the
Deploy
sub-tab.
After all I/O modules have been configured and connected, the enclosure’s
blades can be inserted and booted with full network communication.
Dell PowerConnect-KR 8024-k Switch
The PowerConnect M8024-k switch provides 16 internal 10 GbE ports, four
external 10 GbE SFP+ ports, and one 10 GbE expansion slot for 10 GbE
external uplinks. The expansion slot on the front panel can support:
• A 10 Gb Ethernet module with four optical SFP+ connectors
• A 10 Gb Ethernet module with three copper CX4 uplinks
• A 10 Gb Ethernet module with two copper 10GBASE-T uplinks
This module is hot-swappable and may be installed in Fabric A, B, or C.
book.book Page 53 Wednesday, March 9, 2011 3:11 PM