Filter
Top Products
96 Troubleshooting
MEMORY DOUBLE WORD LOGIC FAILURE AT ADDRESS, READ VALUE EXPECTING VALUE — A memory module
may be faulty or improperly seated. Reinstall the memory modules (see "Memory" on page 129) and, if
necessary, replace them.
MEMORY ODD/EVEN LOGIC FAILURE AT ADDRESS, READ VALUE EXPECTING VALUE — A memory module may
be faulty or improperly seated. Reinstall the memory modules (see "Memory" on page 129) and, if
necessary, replace them.
MEMORY WRITE/READ FAILURE AT ADDRESS, READ VALUE EXPECTING VALUE — A memory module may be
faulty or improperly seated. Reinstall the memory modules (see "Memory" on page 129) and, if necessary,
replace them.
NO BOOT DEVICE AVAILABLE — The computer cannot find the hard drive. If the hard drive is your boot
device, ensure that the drive is installed, properly seated, and partitioned as a boot device.
NO BOOT SECTOR ON HARD DRIVE — The operating system may be corrupted. Contact Dell. See
"Contacting Dell" on page 150.
NO TIMER TICK INTERRUPT — A chip on the system board may be malfunctioning. Run the System Set
tests in the Dell Diagnostics. See "Dell Diagnostics" on page 87.
NOT ENOUGH MEMORY OR RESOURCES. EXIT SOME PROGRAMS AND TRY AGAIN — You have too many
programs open. Close all windows and open the program that you want to use.
OPERATING SYSTEM NOT FOUND — Contact Dell. See "Contacting Dell" on page 150.
OPTIONAL ROM BAD CHECKSUM — The optional ROM apparently failed. Contact Dell. See "Contacting
Dell" on page 150.
A REQUIRED .DLL FILE WAS NOT FOUND — The program that you are trying to open is missing an essential
file. Remove and then reinstall the program.
1
Click the
Start
button and click
Control Panel
.
2
Click
Add or Remove Programs
.
3
Select the program you want to remove.
4
Click
Remove
or
Change/Remove
and follow the prompts on the screen.
5
See the program documentation for installation instructions.
SECTOR NOT FOUND — The operating system cannot locate a sector on the hard drive. You may have a
defective sector or corrupted FAT on the hard drive. Run the Windows error-checking utility to check the
file structure on the hard drive. See the Help and Support Center for instructions. If a large number of
sectors are defective, back up the data (if possible), and then reformat the hard drive.
SEEK ERROR — The operating system cannot find a specific track on the hard drive.
SHUTDOWN FAILURE — A chip on the system board may be malfunctioning. Run the System Set tests in
the Dell Diagnostics. See "Dell Diagnostics" on page 87.
TIME-OF-DAY CLOCK LOST POWER — System configuration settings are corrupted. Connect your computer
to an electrical outlet to charge the battery. If the problem persists, try to restore the data by entering the
system setup program. Then immediately exit the program. If the message reappears, contact Dell. See
"Contacting Dell" on page 150.
book.book Page 96 Tuesday, February 13, 2007 1:50 PM