Filter
Top Products
126 Jumpers and Connectors
6
Turn off the system, including any attached peripherals, and disconnect
the system from the electrical outlet.
7
Open the system.
8
Install the password jumper plug.
See Figure 6-1 to locate the password jumper on the system board.
9
Close the system, reconnect the system to the electrical outlet, and turn
on the system.
10
Assign a new system and/or setup password.
To assign a new password using the System Setup program, see "Using the
System Setup Program" on page 35.
book.book Page 126 Thursday, August 30, 2007 3:30 PM