Filter
Top Products
Scenario 3: VoIP telephone service
Follow this setup if you have telephone service from a Voice over Internet Protocol (VoIP) provider.
Tips for this setup:
• Connect the printer to the port labeled Phone Line 1 or Phone Port on the VoIP adapter. The port labeled Phone
Line 2 or Fax Port is not always active. You may need to pay extra to your VoIP provider if you want to activate
the second phone port.
• To make sure that the phone port on the VoIP adapter is active, plug an analog telephone into the phone port,
and then listen for a dial tone. If you hear a dial tone, then the port is active.
• If you need two phone ports for your devices but do not want to pay extra, then do not plug the printer into the
second phone port. You can use a phone splitter. Plug the phone splitter into the Phone Line 1 or Phone
Port , and then plug the printer and telephone into the splitter.
Note: Make sure you use a phone splitter, not a line splitter. To make sure that you are using the correct splitter,
plug an analog telephone into the splitter and then listen for a dial tone.
Faxing
61