Filter
Top Products
Ethernet Communication Module IFD9507
DVP-PLC Application Manual
38
Returning to default setting:
Check “Factory Setting” box and click on “Yes”.
Note:
If you set up IFD9507 by RS-232, you can return to settings to default ones whether the password is
locked or not. It will take approximately 10 seconds to return to default settings, so DO NOT switch off
the power within the 10 seconds. Besides, you can also press “Reset” button for 2 seconds to return
to default settings.
11 Setting up Configuration by Homepage
This section gives instructions on how to set up IFD9507 by homepage and explanations on each configuration
page. IFD9507 is set up by UDP port 20006; therefore, you have to be aware of the relevant settings of the
firewall. See the explanations below on the homepage.
11.1 Webpage connection
Enabling webpage function
1. Open IE, and enter the IP address of IFD9507 into the address column.
2. See below for the setup page offered by the webpage. Preview all the information in the column on the
left hand side.