Filter
Top Products
Installation
Corinex AV200 Powerline Ethernet Wall Mount
9
1. Identify which is the AP adapter in an existing PLC network. The AP adapter
always shows its AP indicator ON in green. The other adapters are EPs and their
AP indicators will be OFF;
2. Next, press “SYNC/RST” button for around two seconds on the AP adapter until
its AP indicator starts blinking. This opens a configuration period of 30 seconds;
3. During this configuration period, press the “SYNC/RST” button on the new EP
adapter(s) until their AP indicator starts blinking, then release the button.
Exchanging of Network ID and Encryption Key between AP and new EPs is done
automatically. All the new adapters and the AP device finish their configuration
process successfully when their AP indicator flashes three times during 0.5
seconds. All adapters then return to normal operation mode belonging to the
same powerline network.
Note:
1. The adapters during the configuration process shall be within close
proximity such that they are able to communicate with each other without
a network identifier and an encryption key.
2. When adding adapters to the network, the button of the second adapter
should be pressed only after the button of the first adapter has been
released.
2.4.2.2 Factory Reset
Perform the following steps to do a factory reset:
1. Press the adapter’s “SYNC/ RST” button for at least ten seconds (its lower
LED will start blinking in green once the button has been pressed for two
seconds, and will keep blinking for about eight seconds). When the VPI LED
switches OFF, release the button.
2. After five seconds, the VPI LED will switch ON again.
3. At this time, the adapter resets its configuration to the factory default settings
and automatically restarts
The significant factory settings in the AV200 Wall Mount are presented below:
• Default IP is 10.10.1.69
• Default configuration password is “paterna”
• Default factory reset password is “betera”
• Default network ID is the public network ID
• Default Encryption Key is none.