DeWalt AV200 Network Card User Manual


 
LED Definitions
(Buttons from top to bottom)
1. PWR (Upper LED)
Shows the status of the adapter: the LED is on, if the adapter is connected to
power.
2. VPI (Middle LED)
Displays the quality of the powerline link, when the adapter is synchronized with
another adapter on the same network.
3. AP (Lower LED)
Displays the adapter type (its role in the network). If the LED is on, adapter is
Fixed AP (Access point), if the LED is off, adapter is EP (End point).
Connector Definitions
1. LAN: 1x RJ-45 LAN10/100 Ethernet port
7
Installation
Corinex AV200 Powerline Ethernet Wall Mount
AV200
Powerline
Wall Mount
AP
VPI
Power
SYNC/RST
STANDBY
2.4 Functional Description
2.4.1 Standby Button
By default, when plugged in, the adapter is in the ON state. When Standby operation
is desired, the button should be pressed and released at once. This will set the
adapter in energy-saving Standby operation mode. When the adapter is in Standby
operation, the button can be pressed to set the adapter back into the ON mode.