Filter
Top Products
22
Adapter Configuration
Corinex AV200 Powerline Ethernet Wall Mount
3.4.3.2 Network Configuration
Your Corinex AV200 Powerline Wall Mount can be configured to use either DHCP
(automatic IP address assignment), or a fixed IP.
The following parameters are used by the fixed IP configuration. In order for the wall
mount adapter to correctly communicate with other devices on the network, it is
necessary to define a valid IP address, as well as a proper subnet mask and gateway
address. These parameters will be saved in the wall mount adapter’s memory and
activated at the next restart.
After changing any of these parameters, click “OK” to save your changes.
Note: Any change in the Network Settings requires a restart of the wall
mount adapter to take effect.
Note: If you forget the IP address of the device, please recover it with the
utility “getIP,” which is located on the Documentation CD, or download it
from the Corinex website at www.corinex.com.
3.4.4 PHY Configuration
By default, the wall mount adapter transmits over a frequency range anywhere from
2 to 32 MHz, and when an access network is detected, the wall mount adapter
transmits over a range from 13.3 to 33.3 MHz, in order to avoid interference. This
mode change is done automatically and cannot be configured by the user. It is only
possible to enable or disable this “notches” function. The notches pre-defined in the
wall mount adapter correspond to the IARU (International Amateur Radio Union)
band plan for each world region. If the adapter is operating in an environment where
it can cause interference to a HAM radio receiver, it is recommended to enable
notches, in order to block the Powerline signal from the frequency bands used by
radio amateurs.