Filter
Top Products
NANO-PV-D510A User Manual
Page 46
The CompactFlash® slot is connected through an IDE connection. This jumper sets the
CompactFlash® card as the master or slave IDE device.
Setting Description
Open Slave
Closed Master
Table 4-6: CompactFlash® Setup Jumper Settings
Figure 4-7: CompactFlash® Setup Jumper Location
4.4.6 LVDS Voltage Selection
WARNING:
Incorrect voltages can destroy the LCD panel. Make sure to select a
voltage that matches the voltage required by the LCD panel.
Jumper Label: J_VLVDS1
Jumper Type:
6-pin header
Jumper Settings:
See
Table 4-7
Jumper Location:
See
Figure 4-8
The LCD voltage selection jumper sets the voltage of the power supplied to the LCD
panel.