Filter
Top Products
NANO-PV-D510A User Manual
Page 51
Step 3: Connect Power Cable to Power Supply. Connect one of the 4-pin (1x4) Molex
type power cable connectors to an AT/ATX power supply. See
Figure 4-12.
Step 3:
Figure 4-12: Connect Power Cable to Power Supply
4.6.2 Audio Cable Installation
The Audio Cable that came with the NANO-PV-D510A connects to the audio connector on
the NANO-PV-D510A. The audio cable consists of three audio jacks. Mic-in connects to a
microphone. Line-in provides a stereo line-level input to connect to the output of an audio
device. Line-out, a stereo line-level output, connects to two amplified speakers. To install
the audio cable, please refer to the steps below:
Step 4: Locate the audio connector. The location of the 10-pin audio connector is
shown in Chapter 3.