Filter
Top Products
42D-Link DWR-116 User Manual
Section 3 - Conguration
Select Enabled to allow local SNMP
administration. Select Disabled to disallow
local SNMP administration.
Select Enabled to allow local SNMP
administration. Select Disabled to disallow
local SNMP administration.
Enter the password in this eld to allow “Read
only” access to network administration using
SNMP. You can view the network, but no
conguration is possible with this setting.
Enter the password in this eld to gain “Read
and Write” access to the network using SNMP
software.
Enter up to four IP addresses of any trap targets
on your network.
Select the SNMP version of your system.
Click Save Settings to save your changes,
or click Don’t Save Settings to discard your
changes.
SNMP
SNMP Local:
SNMP Remote:
Get Community:
Set Community:
IP 1, IP 2, IP 3,
IP 4:
SNMP Version:
SNMP (Simple Network Management Protocol) is a widely used
network monitoring and control protocol that reports activity on
each network device to the administrator of the network. SNMP
can be used to monitor traffic and statistics of the DWR-116. The
DWR-116 supports SNMP v1 or v2c.