Filter
Top Products
INSTALLATION
2-1-3 LED INDICATION STATUS
Standby/On
Indicator
Lamp
Status
Indicator
Temperature
Status
Indicator
Eco
mode
indicator
DVD
active
indicator
Note
Waiting for power on
Normal operation
Cool lamp down for
90 sec
Eco mode is being
used
DVD player is being
used.
Fan failure.
There is a warning
message displayed
on screen then the
projector will power
itself off.
Overheating
in the projector:
There is a warning
message displayed
on screen then the
projector will power
itself off.
The system will cool
itself down for 8 sec
automatically.
Condition
1. Standby
2. Operating
3. Cooling
4. Eco mode in
use
5. DVD in use
6. Fan
failure
7. Overheating
8. Overheating
while starting
Green
Green
Green
Green
Green
Green
Green
-
-
-
-
Flashing
Green
(0.5 sec
Interval)
-
-
-
-
-
-
-
Red
Red
(1 sec
interval)
-
-
Green
-
-
-
-
-
-
-
Green
-
-
-
Flashing
Green
(1sec interval)
- - - -
2-2 ADJUSTING THE PROJECTOR IMAGE
2-2-1 ADJUSTING THE PROJECTOR HEIGHT
Elevator Button
Elevator Button
1. Press the Elevator buttons. (Drawing 9 and
10)
2. Raise the projector to the desired display
angle, allowing the legs to extend, and then
release the buttons to lock them in position.
3. Use the Adjustable foot (Drawing11) at the
rear of the unit to fine-tune the display
angle.
4. Use the Keystone key on the Remote
Control or in the OSD to correct any
distortion caused by tilting the projector.
(Drawing12)
Elevator foot
Adjustable foot
2-2-2 ADJUSTING THE PROJECTOR ZOOM/FOCUS
Increase (+) Keystone value
Decrease (-) Keystone value
INSTALLATION
Adjust the Zoom ring to adjust image size.
Rotate the Focus ring to focus the image. The
projector will focus at distances from 1.5m
(60in. / 5 ft.) to 10m (394 in. / 32.9 ft.). The
optimum distance is from 1.5 m to 5 m (197 in.
/ 16.5 ft.).
Focus RingZoom Ring
DRAWING 9
DRAWING 10
DRAWING 11
DRAWING 12
DRAWING 13