Filter
Top Products
3-2-4-5 AUDIO 2
Prologic:
Auto: Default setting. The DVD player will automatically
change the output from 2 channels to 6 channels.
On: Sets the function always on.
Off: Sets the function off.
Subwoofer:
On: Sets the subwoofer on.
Off: Sets the subwoofer off.
Factory Set:
On: Restores the default setting.
Off: Keeps the user's setting.
DRAWING 61
Control Panel and Remote Control
APPENDICES
4-1 TROUBLESHOOTING
1. No Images appears
Check the power cable connection at the power inlet of the projector and at the
wall outlet.
Confirm that the main power switch at the rear of the projector is in the on
position.
Check the Standby/on button indicator. (Section 3-1)
Confirm that the lens cap has been removed.
Make sure the source device is properly connected to the projector, and is
outputing a signal.
Press "Source" button on either the projector or the Remote Control to ensure
that correct source is selected.
2. Image is blurred
Ensure the distance between the projector and the screen is within the focus
range of the lens. (Section 2-2)
Adjust the focus ring.
3. Image is too dark
Adjust the contrast or brightness in the image menu of projector properly.
Adjust the brightness in the setup menu of DVD player.
Has the lamp reached the end of its life? If so replace the lamp.
4. Computer Image is unstable or the projector isn't projecting the whole image.
Press "SYNC" button either on the projector or the Remote Control to
synchronize the computer output signal.
Use "Image" menu to adjust the tracking or frequency.
Verify that the computer's output resolution to the projector is less than or
equal to 1024 x 768.
5. Image is stretched when displaying 16:9 DVD.
Adjust the "Aspect Ratio" in the OSD of projector.
Adjust the "TV Shape" in the OSD of DVD player.