Filter
Top Products
CAUTION
* Do not touch the lamp immediately after it has been used: it will be extremely hot.
Allow the fan to finish its cooling process, then turn the projector off, and disconnect
the power cord. Then allow at least one hour for the lamp to cool down before handling.
* Do not remove any screws other than the lamp cover screw and the lamp housing
screws. Removing other screws could result in electric shock.
* Although the mercury content of the lamp is minuscule, spent lamps should be
treated as hazardous waste. Consult federal, state/provincial or local regulations for
proper disposal.
APPENDICES
To reset the lamp timer
1. Press the Menu button on control panel
or remote controller.
2. Go into the system menu and move the
cursor to the lamp reset item.
3. Select "Yes" to execute the lamp reset
and the lamp hours will reset to 0 hour.
Important
Continuing to use the lamp after the replace the lamp message has been displayed on
the screen may result in the lamp exploding. If this occurs, pieces of glass may scatter
inside the projector, and out into the room. If this occurs, do not touch them, as the
pieces of glass may cause injury. The bulb contains a small amount of mercury:
ventilate the area well. Contact your dealer for servicing: do not attempt to service the
projector yourself.
DRAWING 66
APPENDICES
4-2-2 CLEANING THE PROJECTOR
Cleaning the cabinet
Wipe lightly with a soft, dry cloth. If the cabinet is very dirty, clean it with a soft,
dampened cloth using mild commercial cleaner and finish with a dry cloth. Do not use
liquid or aerosol cleaners.
Cleaning the lens
Clean the lens carefully by using a blower or lens paper to prevent creating any
scratches on lens.