Filter
Top Products
ATCA-7350 Control via IPMI Programmer’s Reference (6806800H29E)
Supported Commands Chassis Device Commands
20
2.1.7.1.2 System Boot Options Parameter #96
This boot parameter is an Emerson-specific OEM boot parameter. Its definition is given in the
following table.
There is no Set Selector or Block Selector with this command.
2.1.7.1.3 System Boot Options Parameter #98
This boot parameter is an Emerson-specific OEM parameter.
This timer specifies how long the IPMC waits for the payload to shut down gracefully. If the
payload software does not configure its OpenIPMI library to be notified for graceful shutdown
requests, the IPMC shuts down the payload when the timer expires.
Table 2-10 System Boot Options Parameter #96
Boot Option
Parameter Data Description
1 This parameter specifies the processor ID for which the boot option is to be set.
This parameter has to be 0 always for this blade.
2 This parameter is used to select the BIOS boot bank of which the payload shall
boot from:
[7:1] Reserved
[0] Default/backup boot flash selection
The System Boot Options parameter #96 is non-volatile. Its parameter data remains
preserved after IPMC power cycles and firmware upgrades.
Table 2-11 System Boot Options Parameter #98
Boot Option Parameter
Data Description
1 This parameter specifies the Graceful Shutdown Timeout LSB (given in
100 msec)
2 This parameter specifies the Graceful Shutdown Timeout MSB (given in
100 msec)