Filter
Top Products
LAN Device Commands Supported Commands
ATCA-7350 Control via IPMI Programmer’s Reference (6806800H29E)
21
There is no Set Selector or Block Selector with this command.
2.1.7.1.4 System Boot Options #99
This parameter is an Emerson-specific OEM parameter. It is used to enable or disable BIOS
and FRU write protection
There is no Set Selector or Block Selector with this command. The Boot Option parameter data
returned with the IPMI command Get System Boot Options provides the write protect status of
the two BIOS flashes and of the FRU information (one byte for each instance).
2.1.8 LAN Device Commands
The System Boot Options parameter #98 is non-volatile. Its parameter data remains
preserved after IPMC power cycles and firmware upgrades.
Table 2-12 System Boot Options Parameter #99
Boot Option Parameter
Data Description
1 This parameter enables/disables BIOS and FRU write protection:
[7:4] Bios ID (0= Boot Bank A, 1= Boot Bank B, 2= FRU information,
others reserved)
[3:0] write protect enable/disable (0= disable, 1= enable, others reserved)
Table 2-13 Supported LAN Device Commands
Command NetFn (Request/Response) CMD
Set LAN Configuration Parameters 0x0C/0x0D 0x01
Get LAN Configuration Parameters 0x0C/0x0D 0x02
Set SOL Configuration Parameters 0x0C/0x0D 0x21
Get SOL Configuration Parameters 0x0C/0x0D 0x22