Filter
Top Products
ATCA-7350 Control via IPMI Programmer’s Reference (6806800H29E)
Supported Commands Serial Output Commands
24
2.3.1.1 Set Serial Output Command
The Set Serial Output command selects the serial port output source for a serial port connector.
2.3.1.1.1 Request Data
The following table lists the request data applicable to the Set Serial Output command.
2.3.1.1.2 Response Data
The following table lists the response data applicable to the Set Serial Output command.
2.3.1.2 Get Serial Output Command
The Get Serial Output Command provides a way to determine which serial output source goes
to a particular serial port connector.
Table 2-16 Request Data of Set Serial Output Command
Byte Data Field
1 LSB of Emerson IANA Enterprise number. A value of 0xCD has to be used.
2 Second byte of Emerson IANA Enterprise number. A value of 0x65 has to be used.
3 MSB of Emerson IANA Enterprise number. A value of 0x00 has to be used.
4 Serial connector type
0: Face plate connector
All other values are reserved.
5 Serial connector instance number. A sequential number that starts from 0.
6 Serial output selector
0: payload serial console (default 9600 baud)
2: IPMC(default baud rate 115200 baud)
All other values are reserved.
Table 2-17 Response Data of Set Serial Output Command
Byte Data Field
1 Completion code
2 LSB of Emerson IANA Enterprise number.
3 Second byte of Emerson IANA Enterprise number.
4 MSB of Emerson IANA Enterprise number.