Emerson SERIES 610 Power Supply User Manual


 
Operation
61
3.2.12 Meter Calibration Screen
Go to the Master Menu and move the highlighted cursor to METER CALIBRATION. Press the
Select pad and the Meter Calibration screen is displayed.
The Meter Calibration screen enables a Liebert field-service engineer to adjust the calibration of the
UPS metered functions at each cabinet. Access to these settings is limited by the Security Access con-
trol.
Figure 49 Meter calibration screen
NOTE
Bypass volts are calibrated only at the System Control Cabinet (SCC). Input amps, DC volts,
DC amps and temperature are calibrated only at the UPS modules.
!
CAUTION
Meter calibrations are factory-set and should not require adjustment. Contact Liebert Global
Services for meter calibration.
!
WARNING
Do not attempt to calibrate meters without adequate training. Meter calibration requires
special test equipment, access to test points in sensitive circuitry and exposure to hazardous
voltage.
UP: CURSOR UP
DOWN: CURSOR DOWN
SELECT: CHOOSE
METER CALIBRATION
SECURITY ACCESS
INPUT VOLTS
INPUT VOLTS
INPUT VOLTS
INPUT AMPS
INPUT AMPS
INPUT AMPS
PHASE A-B
PHASE B-C
PHASE C-A
PHASE A
PHASE B
PHASE C
OUTPUT VOLTS
OUTPUT VOLTS
OUTPUT VOLTS
OUTPUT AMPS
OUTPUT AMPS
OUTPUT AMPS
TEMPERATURE
PHASE A-B
PHASE B-C
PHASE C-A
PHASE A
PHASE B
PHASE C
D.C. VOLTS
D.C. AMPS