Filter
Top Products
Printer Server Installation 2-33
Reset to Factory Defaults
Before resetting to factory defaults, we recommend that you print out a
configuration page. Using the command described below will reset the
printer server to its factory defaults.
• The printer server will reset to factory defaults when power is cycled.
• The IP address and subnet mask are reset to NONE (000.000.000.000).
• Non-volatile memory is reset to factory defaults.
To reset to factory defaults:
1) Obtain privileged status.
2) Enter this command:
>
Server>> initialize [server] [delay delay_min]
[default]
delay Indicates reintialization will not take place until after a
specified period of time.
delay_min Specifies the time before the server is stopped and
the initialization process begins. The default is 1
minute.
default Resets the server to factory defaults
3) Cycle printer power.