Filter
Top Products
Device VLAN Configuration Screen
VLAN Configuration 3-13
3. Use the arrow keys to highlight the SAVE command at the bottom of the screen.
4. Press ENTER. The message “SAVED OK” displays.
3.4.7 Changing the Forwarding Mode
To change the forwarding mode of the switch, proceed as follows:
1. Use the arrow keys to highlight the Forward Default VLAN Out All Ports field.
2. Press the SPACE bar or BACKSPACE to toggle between YES and NO. The YES selection
places the default VLAN (VLAN ID=1) in the Port VLAN Lists of all ports on the switch. The
NO selection removes the default VLAN from the Port VLAN Lists of all ports, unless those
ports have a PVID of 1 (those belonging to only the Default VLAN).
3. Use the arrow keys to highlight the SAVE command at the bottom of the screen.
4. Press ENTER. The message “SAVED OK” displays.
3.4.8 Paging Through the VLAN List
To display additional VLANs that do not display in the current VLAN List as shown on the screen,
use the NEXT or PREVIOUS commands located at the bottom of the screen, as follows:
1. To display the next screen, use the arrow keys to highlight NEXT. Press ENTER to view the
entries on the next screen.
2. To display the previous screen, use the arrow keys to highlight PREVIOUS. Press ENTER to
view the entries on the previous screen.
NOTE: The default VLAN cannot be disabled.
NOTE: The NEXT and PREVIOUS fields will only display if there are further VLAN List
entries to page through.