Filter
Top Products
xv
ABOUT THIS SUPPLEMENT
This document is a supplement to the existing SmartSTACK Ethernet
ELS10-27TX User Guide and should be used in conjunction with the
SmartSTACK Ethernet ELS10-27TX User Guide. The information in this
document describes the changes resulting from firmware revision 1.01.00.
This manual is for system administrators responsible for configuring, monitoring,
and maintaining the SmartSTACK Ethernet ELS10-27TX (also referred to as
ELS10-27). You should have a familiarity with networking concepts and
principles. In addition, a basic understanding of SNMP is helpful.
The contents of each chapter are described below.
• Chapter 1, Introduction, provides an overview of new VLAN and Workgroup
functionality as well as additional functions for the SmartSTACK Ethernet
ELS10-27TX.
• Chapter 2, Configuring VLANs Using LCM, provides instructions on how
to configure the SmartSTACK Ethernet ELS10-27TX VLAN functions using
LCM.
• Chapter 3, Configuring VLANs Using SNMP, provides instructions on how
to configure the SmartSTACK Ethernet ELS10-27TX VLAN functions using
SNMP.
• Chapter 4, VLAN MIB Objects, provides a list of VLAN Configuration MIB
Objects.
• Chapter 5, Configuring Workgroups Using LCM, provides an overview of
workgroup configurations and LCM commands.
• Chapter 6, Configuring Workgroups Using SNMP, provides an overview of
workgroup configurations and SNMP commands.
• Chapter 7, Workgroup MIB Objects, provides a list of Workgroup MIB
Objects used to configure Workgroups using SNMP.
• Appendix A, Virtual LANs, describes how the switch uses VLANs to create
isolated network domains, and provides illustrations of VLAN switch
configurations.