Filter
Top Products
Introduction
1-7
1.3.8 Restricting VLANs (802.1Q Mode)
This command will allow you to specify a list of VLAN IDs that should not be
dynamically learned by GVRP. When the management processor receives a
GVRP packet, it checks this database to determine if the learning of this ID
should be restricted.
For usage, refer to the VLAN Command in Chapter 2, Enhancements to LCM
Commands.
1.3.9 Enable GVRP
GVRP can be enabled on a per port basis using the Port command.
For further information, refer to the Port Command in Chapter 2, Enhancements
to LCM Commands.
NOTE
There is no support for GVRP with ELS10-27TX Version 1.01.00.
GVRP will be supported in a subsequent release.
NOTE
There is no support for GVRP with ELS10-27TX Version 1.01.00.
GVRP will be supported in a subsequent release.