Filter
Top Products
2-2
Enhancements to LCM Commands
Parameters that appear in all capital letters, for example workgroups
[PORT-RANGE]
, indicate that you must enter a value for that parameter. If a
string of parameters is displayed between braces, for example
[name
{add|PORT-RANGE}]
, you must select one of the displayed options. For
example, if you wanted to add ports to a workgroup, you would enter:
ELS10-27>workgroup alpha add 23, 24
For example, if you wanted to add a range of ports in a workgroup, you
would enter:
ELS10-27>workgroup omega add 2-18
For a complete list of commands, refer to the SmartSTACK Ethernet ELS10-
27TX User Guide.
2.3 LCM COMMAND SUMMARY
This section contains a subset of LCM commands and syntax.
2.3.1 Subset of LCM Commands
The following is a subset of LCM commands and definitions.
Use ... To ...
help or ? display this menu
ipaddr [IPADDR [MASK]] set or display IP addresses
port [? for syntax] set or display port parameters
reboot [? for syntax] reboot the unit after SECONDS
switch [? for syntax] set or display switch parameters
vlan [? for syntax] configure IEEE Vlans
workgroup [? for syntax] set or display workgroups