Filter
Top Products
2-4
Enhancements to LCM Commands
2.4 BASIC LCM COMMANDS
To manage the SmartSTACK Ethernet ELS10-27TX using LCM, you first must
connect the switch to an ASCII terminal or terminal emulator.
To use LCM, begin by pressing the Enter key several times to get the LCM
prompt (ELS10-27>).
2.4.1 Help
Displays the menu of available commands. Help can also be displayed by typing
a question mark (?).
Telnet support allows you to telnet to the device and gain access to LCM. The
device allows 4 sessions. The only password for telnet is the Read-Write
community name for the device and this name allows full access. You are not
allowed to modify passwords via a Telnet session. If an IP address is added or
modified using Telnet, the new address will not take affect until the next reboot.
The Read-Write community name is not used to make modifications to the
configuration. Reading the configuration can be accomplished without
knowledge of the Read-Write community name. There is no support for the
Read-Only community name. Any name other than the Read-Write Community
name will allow for Read-Only access.
2.4.2 Erase
Entering erase to erase the current SmartSTACK Ethernet ELS10-27TX
configuration returns all parameters to the default values. You will be prompted
to complete the command.
2.4.3 Exit or Logout
This command logs you out of LCM. (The exit command is functionally
equivalent to the
logout command.)
NOTE
You must type “YES” and reboot the system to implement the
change. If only “Y” is entered, the change will not be implemented.