Filter
Top Products
3-1
CHAPTER 3
CONFIGURING VLANS USING SNMP
3.1 OVERVIEW
This chapter describes how to create, delete or modify VLANs on the
SmartSTACK Ethernet ELS10-27TX using SNMP. This chapter describes the
procedure for using the following VLAN Configuration MIBs:
• The Config Table
• The Config Egress List
• 802.1Q Mode
• The Filter GVRP table
• The Static MAC table
This chapter should be used in conjunction with Chapter 4, VLAN MIB Objects,
in this manual.
3.2 THE CONFIG TABLE
The SmartSTACK Ethernet ELS10-27TX is capable of supporting 32 VLANs.
The index into the VLAN table is from 0 to 31. The present table entries can be
read, but not written, by setting the index to a value of 0 - 31. When configuring
an entry, several values are used. These values are the VLAN ID, the ports on the
VLAN, an IP address, an IP mask, and a VLAN name.
If the index is between 0 and 31, and one of these variables is read, the presently
configured table entry will be returned.
To create, modify, or delete a VLAN entry, a multiple step process is required.
The local variables must first be set with the values desired, followed by a
command to process the variables. For a list of configuration MIBs, refer to
Chapter 3, VLAN MIB Objects.