Filter
Top Products
94 Setting Up Network Projection
4. Enter up to two IP addresses for notification.
You can enter a number from 0 to 255 in each field of the address.
However, the following IP addresses cannot be used: 127.x.x.x,
224.0.0.0 to 255.255.255.255 (where x is a number from 0 to
255).
5. If your network environment uses an AMX controller, select ON
to allow the projector to be detected by AMX Device Discovery.
Connecting With Windows Vista
If you have Windows Vista, you can use the Network Projector
function to connect to the projector without installing the EasyMP
software. This provides a quick, easy way to connect wirelessly,
though with limited capabilities. Not all the features available with
EMP NS Connection are possible when connecting using the Vista
network projector function. All performances are enhanced when you
use EMP NS Connection.
Follow these steps:
1. Turn on the projector.
2. Press the
EasyMP button on the remote control. The standby
screen appears.
note
Use only the Epson
802.11a/b/g wireless module
in the projector. If you see a
message asking you to insert
a LAN or memory card,
check to make sure your
802.11a/b/g module is
properly inserted (see the
Quick Setup sheet).