Filter
Top Products
Problem Solving 51
The light is green.
Epson MovieMate is operating correctly. If you don’t see a picture, press the button on
the remote control to return to normal operation, or open the lens cover slide.
The warning light is flashing orange and the light is flashing red.
High-speed cooling is in process. If Epson MovieMate gets too hot again, projection stops
automatically. Make sure Epson MovieMate is at least 8 inches (20 cm) away from the wall.
Clean or replace the air filters if necessary (see page 43). If you are using Epson MovieMate at
an altitude above 4900 feet (1500 meters), turn on High Altitude Mode (see page 41).
The warning light is flashing orange.
The lamp needs to be replaced. See page 45.
The light is red and the warning light is red.
Epson MovieMate is too hot and has turned off the lamp. Make sure Epson MovieMate is at
least 8 inches (20 cm) away from the wall.
Clean or replace the air filters if necessary (see page 43). If you are using Epson MovieMate at
an altitude above 4900 feet (1500 meters), turn on High Altitude Mode (see page 41).
Let Epson MovieMate cool for five minutes. When the light turns orange, press the
button to turn the lamp back on. If the status doesn’t change, wait a few minutes, then
unplug Epson MovieMate and contact Epson. See page 56.
The light is red and the warning light is flashing red.
The lamp may be incorrectly installed, the lamp cover may be loose, or the lamp may be
broken. Wait a few minutes, then turn off the power and check the lamp. See page 47. If the
lamp is broken, or the lights continue to flash after you turn the power back on, unplug
Epson MovieMate and contact Epson. See page 56.
The light is red and the warning light is flashing red.
Epson MovieMate has a problem with its fan or temperature sensor. Wait a few minutes, then
unplug Epson MovieMate and contact Epson. See page 56.
The light is red and both warning lights are flashing red.
Epson MovieMate may have an internal error. Wait a few minutes, then press . Unplug
the power cable, then plug it in again and press . If the lights continue to flash, unplug
Epson MovieMate and contact Epson. See page 56.