Filter
Top Products
Problem Solving 55
Problems with External Video Equipment
No picture appears on the screen.
■ Make sure the equipment is turned on.
■ Press the button on Epson MovieMate or on the remote control.
■ Press the or Play button on the external equipment.
■ Make sure you don’t have cables connected to more than one video port. You can only
use one connection at a time (see page 22).
You see the message No Signal.
■ Make sure the equipment is turned on.
■ Make sure your cable(s) are connected correctly (see page 22).
■ Press the button on Epson MovieMate or the remote control to select the external
video source. Allow a few seconds for Epson MovieMate to sync up.
You see the message Signal not supported.
Press the button on the remote control and check the Video Signal setting (see
page 40).
The picture is cut off (too large) or too small.
Press the button on the remote control and select the appropriate aspect ratio.
Press the button on the remote control and select the appropriate zoom setting.
The picture is distorted.
■ If you’re using an extension cable, electrical interference may affect the signal.
■ Check the solutions on pages 53 and 54.
The colors are not right.
■ Press the button on the remote control and check the Video Signal setting (see
page 40).
■ Press the button on the remote control to select the best setting for your viewing
environment.
■ Adjust the Color Saturation or Tint settings. See page 38.