Filter
Top Products
Configuring the printer
3-5
3.3 Explanation of the printouts on the previous pages
The heading PRINT OUT gives information about the VERSION of the printer's
firmware.
The next two headings are followed by two columns of standard settings:
S INTERFACE - for communication between the computer operating system
and the printer it is necessary to have the same communication settings or
features. The standard settings are:
CI - 4040 CI - 4050
- 8 Kbyte buffer - 8 Kbyte buffer
- 8 bit - 8 bit
- parallel interface type - shared interface type
- 9600 baud - 9600 baud
- parity ignore - parity ignore
- DTR protocol - DTR protocol
- CTS ignore.
S ADJUSTMENT - all parameters are for adjustment of the printer and the
paper (see also the following pages).
The last part of the printout is a list with all MACRO settings. In this case
MACRO 1 is marked with an asterisk (’) which identifies it as the active macro.
If you make modifications in the active macro without saving them you will find
the new settings under the heading CURRENT SETTINGS. Unless they are
saved, the modifications will stay active only until the printer is switched off in
which case the macro settings marked with the asterisk will be reactivated.