Filter
Top Products
3.
Locate the multi-colored power supply cable with the small
connector. This cable is attached to the system board rather
than the power supply.
4.
Position the power supply cable connector so that the holes
fit over all the pins. The red wire on the cable will align
with pin 1 identified at the power connector on the circuit
board of the drive. Push in the connector.
Caution
If you do not align the cable connector correctly, you could
severely damage your hard disk drive when you push it in.
Post-installation Procedures
After you install or remove your drive(s) and replace the cover
on your computer, you need to run the SETUP program to
define the correct configuration for your newly installed drive.
See Chapter 2 for instructions.
5-20
Installing and Removing Drives