Filter
Top Products
33
Turning On the Projector
Turning On the Power and Projecting Images
PROCEDURE
Check that the Power indicator has stopped flashing
and is lit orange.
Turn on the power for all equipment connected to the
projector.
For a video source, press the [Play] button at the video source to
start playback if necessary.
Press the [Power] button on either the projector's
control panel or the remote control to turn on the
power for the projector.
A beep will sound to indicate that the projector is starting up.
The Power indicator flashes green.
After a short period it stops flashing and lights steadily, and
projection starts.
Wait until the Power indicator lights green (it normally takes
about 40 seconds to change).
TIP
The Password Protect setting may cause the password entry screen to
be displayed each time the power is turned on.
If this happens, enter the password. p.27
1
Lit orange
2
3
Remote control
Changes from flashing to lit green
TIP
•If the Power indicator is flashing green, operation of the [Power]
buttons is disabled.
•Depending on the settings, the message "No Signal." may appear.
See "Setting" - "Message" p.58