Filter
Top Products
Setting the Jumpers
If you need to change any jumper settings, follow these steps:
1.
Refer to the illustration on page 4-3 to locate the jumpers,
2.
If there are any option cards installed, and you want to
change the setting for jumper J3, you may need to remove
the cards. See page 4-19.
3.
A jumper’s setting is determined by where the jumper is
placed on the pins. For three pin jumpers, the jumper
connects pin 1 and the middle pin (position A) or pin 3 and
the middle pin (position B), as shown below.
In the off position, a three pin jumper sits on only one of the
end pins. To move a jumper from one position to the other,
use needle-nose pliers or tweezers to pull it off its pins and
gently move it to the desired position.
I
I
Caution
Be careful not to bend the jumper pins or damage any
surrounding components on the main system board.
4.
Replace any option cards you removed. See page 4-14 for
instructions.
4-8 Installing and Removing Options