Filter
Top Products
1 • Setting Up the Projector
24
4. To use the ELP Link III software or to use the Effects buttons on
the remote control, connect one end of the serial cable to the
SERIAL terminal on the square end of the main cable.
Connect the other end of the serial cable to the serial port on the
back of your computer.
Note: You will not be able to use ELP Link III software if your system
has only one serial port that is being used to support a serial mouse.
5. Tighten the screws on all connectors.
5300.book Page 24 Tuesday, April 13, 1999 4:19 PM