Filter
Top Products
3 • Using the Projector Menus
82
Video Menu (Image Source = Video)
The Video menu enables you to make adjustments to the projected
image. The following options are available when the image source is
Video.
Note: The projector’s image source must be set to Video, and the video
source (such as a VCR or camcorder) must be connected and operating for
you to access these menu options (for example, the projector must actually
be projecting the image from your video tape, if you’re using a VCR).
Menu item Description
Brightness Lightens or darkens the overall image. Increase brightness to lighten
an image, or decrease it to darken the image.
Contrast Adjusts the degree of difference between light and dark areas.
Increase the contrast to make light areas lighter and dark areas
darker. Decrease it to minimize the difference between the lightest
and darkest areas of the image.
Sharpness Adjusts the sharpness of the screen image.
Color Adjusts color density. Increase the setting for darker and more
opaque colors. Decrease it for lighter and less opaque colors.
Tint
(NTSC only)
Adjusts the red-green color balance of the screen. Increase tint to add
more green, or decrease it to add more red.
Mode Specifies the video signal system. Normally this signal system setting
should be left at AUTO to automatically detect the type of video
signal. If automatic selection is not possible for some reason, use this
menu to manually specify NTSC, PAL, or SECAM.
5300.book Page 82 Tuesday, April 13, 1999 4:19 PM