Filter
Top Products
2 • Using the Projector
68
Note: The projector may not respond to remote control commands in these
conditions: ambient light is too bright; a certain type of fluorescent light is
present; a strong light source (such as direct sunlight) shines into the
infrared receiver; or other equipment emitting infrared energy is present
(such as a radiant room heater). Correct these conditions to use the remote
control or control the projector from a computer.
The following table summarizes the remote control functions.
Button Function
Menu Displays or hides the menu.
Source Switches between Computer 1 and Computer 2, and from video
to computer. (When the Computer 2 BNC switch on the back of
the projector is set to BNC, the source is switched to 5 BNC.)
Pointer button Use the pointer button to navigate the menus or use the remote
as a mouse pointer when the projector is connected to the
computer with the main cable and the mouse cable.
Effects buttons Use to display special effects in conjunction with the ELP Link III
software. (See page 96 for instructions.)
Top
multi-purpose
button
Acts as a right mouse click, selects a menu option, and activates
other custom functions.
Bottom
multi-purpose
button
Acts as a left mouse click, selects a menu option, and activates
other custom functions.
Blank Clears the screen of special effects and switches to a blue or
black display, or a user logo.
5300.book Page 68 Tuesday, April 13, 1999 4:19 PM