Filter
Top Products
84 Presenting Through a Wireless Network
Removing the Wireless 802.11g Card
Follow these steps to remove the card from your projector.
1. If you’re running NS Connection, click
Disconnect on the
control bar.
2. Check the card access light to make sure it isn’t flashing. Then
press the eject button. The button pops out.
3. Press the eject button again. The wireless card partially ejects.
4. Pull the card straight out. Then press the eject button back in to
prevent it from being damaged.
Click
Disconnect
caution
Never remove the card while
the card indicator light is
green or when projecting
wirelessly. You may damage
the card or lose data.
Access light
Eject button
Banff-Toronto User's Guide.book Page 84 Thursday, January 20, 2005 5:00 PM