Filter
Top Products
When formatting is complete, any bad tracks are flagged, and you see
a series of messages like these:
Format finished.
Flagging bad tracks...
Cylinder is xxxx, head is yy
Format completed.
Press ENTER to return to the menu.
Flagged tracks are identified by xxxx and yy. At this point, press
Enter to return to the HARD DISK FORMAT MENU.
If there are any tracks with other errors, scanning stops and you see
this message:
Scanning cancelled.
Warning: This drive has an unflagged error(s),
or is unformatted.
Press ENTER to return to the menu.
Press
Enter.
This may mean that the drive has never been formatted
or that an error was not flagged. If you see this message, it is best to
consult your dealer.
If you want to format the disk after receiving this error message, do
the following:
1.
If the drive is not formatted, perform the Unconditional format
(Option 2) and enter any tracks you know are bad in the Bad
Track Table. (See “Unconditional Format” below.)
2.
Run the Destructive surface analysis (Option 3) to flag any
remaining bad tracks. (See “Destructive Surface Analysis,” which
appears later in this chapter.)
3.
Run the Conditional format again. No errors should occur; if one
does, contact your dealer.
Physically Formatting a Hard Disk D-5