Filter
Top Products
Contact your Epson dealer to obtain a new lithium battery and fol-
low these steps to install it:
1.
2.
3.
4.
5.
6.
7.
Follow the instructions in Chapter 4 to remove the main unit’s cover.
Locate the battery just behind the front panel on the side with the
Epson Equity II logo.
,
To disconnect the battery, grip the brown battery connector on the
main system board and pull it straight up.
Remove the screw on the plate that secures the battery and set the
screw and the plate aside.
Lift out the battery.
Insert the new battery and replace the cover plate and screw.
To connect the new battery, insert the new battery’s connector into
the main system board.
Replace the main unit’s cover as described in Chapter
4.
After you install a new battery, you need to run the MS-DOS SETUP
program to re-enter information about your system configuration and
reset the correct date and time.
50