Epson ET-2500 Fax Machine User Manual


 
ampere rating of all devices plugged into the wall outlet does not exceed the wall outlet's ampere
rating.
Always turn off the product using the power button, and wait until the power light stops flashing before
unplugging the product or cutting off power to the electrical outlet.
If you will not be using the product for a long period, unplug the power cord from the electrical outlet.
Place the product on a flat, stable surface that extends beyond its base in all directions. It will not
operate properly if it is tilted or at an angle.
Allow space behind the product for the cables, and space above the product so that you can fully raise
the document cover.
Leave enough space in front of the product for the paper to be fully ejected.
Avoid locations that are subject to rapid changes in heat or humidity, shocks or vibrations, or dust.
Do not place or store the product outdoors.
Do not place the product near excessive heat sources or in direct sunlight.
Leave enough room around the product for sufficient ventilation. Do not block or cover openings in the
case or insert objects through the slots.
Keep the product away from potential sources of electromagnetic interference, such as loudspeakers
or the base units of cordless telephones.
When connecting the product to a computer or other device with a cable, ensure the correct
orientation of the connectors. Each connector has only one correct orientation. Inserting a connector
in the wrong orientation may damage both devices connected by the cable.
Do not touch the flat white cable inside the product.
Do not move the print head by hand; this may damage the product.
Do not spill liquid on the product or use the product with wet hands.
Do not use aerosol products that contain flammable gases inside or around the product. Doing so may
cause fire.
Do not press too hard on the document table when placing originals.
Do not open the scanner section while the product is copying, printing, scanning, or performing any
other functions.
Be careful not to trap your fingers when closing the document cover or scanner.
Except as specifically explained in your documentation, do not attempt to service the product yourself.
Unplug the product and refer servicing to qualified service personnel under the following conditions: if
the power cord or plug is damaged; if liquid has entered the product; if the product has been dropped
189